What is the default configuration and state of a 1 bit port/pin (or others for that matter) after reset.
i.e. what would be the state (and config) of any of the unused 1 bit ports (excluding SPI pins) on the L1-64 when it access the flash. Obviously I am assuming a default SPI boot process in this example.
I couldn't find this in the docs, I assume it is consistent.
Initial pin/port configuration/status for L series silicon
-
- XCore Legend
- Posts: 1274
- Joined: Thu Dec 10, 2009 10:20 pm
-
- XCore Addict
- Posts: 165
- Joined: Wed Feb 10, 2010 2:32 pm
When none of the ports connected to a pin are enabled, the internal pullups (G4) / pulldowns (L1) are active. Note that these can not be relied upon to drive out of the XCore: if you need a specific external value you should provide an external pullup/down strong enough to overcome the internal ones.Folknology wrote:What is the default configuration and state of a 1 bit port/pin (or others for that matter) after reset.
Ports are brought into use by declaring them within XC.