Hi all,
Just received my Multifuncion Audio kit and I have a problem!
As soon as I received it I plugged in into my Mac and worked so I presume that it is pre-loaded with the USB Class 2.0 audio framework.
I opened the framework in xTime composer, I plug the 12V plug into the board and I connect it via the supplied xtag 2 adapter connected to the USB port. The adapter is correctly found in the IDE but as soon as I try to flash I get the error "Cannot load image, XCore 0 is not enabled".
Any possible solution?
Many thanks
Daniele
Multifun audio board "Cannot load image, XCore 0 is not en."
-
- Member
- Posts: 11
- Joined: Fri Nov 14, 2014 4:19 pm
-
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
Have a look at the answer in the following Q&A section:
http://www.xcore.com/questions/1902/wha ... ot-enabled
http://www.xcore.com/questions/1902/wha ... ot-enabled
-
- Member
- Posts: 11
- Joined: Fri Nov 14, 2014 4:19 pm
Solved thanks.
I was compiling for the wrong target board.
I was compiling for the wrong target board.