XC-1 Dimensions
-
- Respected Member
- Posts: 279
- Joined: Fri Dec 11, 2009 1:34 pm
XC-1 Dimensions
Has anyone got dimensions of the XC-1 with the locations and size of the headers labelled? I'm designing a board to slot on top and was hoping for something a little more accurate than using a ruler.
-
- Respected Member
- Posts: 363
- Joined: Thu Dec 10, 2009 10:17 pm
Download the gerbers off the xmos website and measure those. On the XC-2 i found that all the pins fit a 2,54mm grid so you can use a prefboard.
-
- Respected Member
- Posts: 279
- Joined: Fri Dec 11, 2009 1:34 pm
Do have any recommendations for software to view and measure the gerbers?
-
- XCore Expert
- Posts: 546
- Joined: Thu Dec 10, 2009 10:41 pm
- Location: St. Leonards-on-Sea, E. Sussex, UK.
I imported the top layer into the Pulsonix PCB software I used and added the most important dimensions. A GIF of a screen-dump with the dimensions is here:
http://www.leonheller.com/images/XC-1.gif
I can add any more dimensions you need. You could download the Pulsonix demo and import my PCB file into it, and add your own dimensions. You could import the Gerber yourself, but you wouldn't be able to save the PCB.
I've added a PDF:
http://www.leonheller.com/images/XC-1.pdf
http://www.leonheller.com/images/XC-1.gif
I can add any more dimensions you need. You could download the Pulsonix demo and import my PCB file into it, and add your own dimensions. You could import the Gerber yourself, but you wouldn't be able to save the PCB.
I've added a PDF:
http://www.leonheller.com/images/XC-1.pdf
-
- Respected Member
- Posts: 279
- Joined: Fri Dec 11, 2009 1:34 pm
Thanks, Leon.