http://www.liquidware.com/category/Illuminato+X+Machina
that's quite neat altrnative to xmos, blogger community seems to be quite excited!
so it's a LiquidWare product as i figured..
this looks very similar to XK-1, isn't it?
-
- Active Member
- Posts: 50
- Joined: Wed Dec 16, 2009 6:04 pm
- Location: London
-
- XCore Expert
- Posts: 546
- Joined: Thu Dec 10, 2009 10:41 pm
- Location: St. Leonards-on-Sea, E. Sussex, UK.
Each node is a 72 MHz ARM, which doesn't have anything like the performance of an XS1-L1. Someone mentioned XMOS on the blog.
Leon
Leon
-
- XCore Addict
- Posts: 238
- Joined: Thu Dec 17, 2009 5:15 am
ARM machines and Intel winces.
It surely can't compare to an XK-1.
look around there's a lot of bot boards.
Its fits well in multipleo bots, and LP devices.
Illuminati inside for your kid's, thats "Great!".
Is not anything sacred anymore, "Geeeze!".
It surely can't compare to an XK-1.
look around there's a lot of bot boards.
Its fits well in multipleo bots, and LP devices.
Illuminati inside for your kid's, thats "Great!".
Is not anything sacred anymore, "Geeeze!".
-
- Active Member
- Posts: 60
- Joined: Tue Feb 16, 2010 8:21 am
- Location: Sweden
Looked pretty cool, but I think that's about it. The Illuminato X Machina is a cool idea, that people might play with for a while or perhaps use in research, while the XK-1 is more of a finished product that can be used immediately in commercial products or prototypes.
Though, you ought to put a tricolor led on the XK-1 too :)
Though, you ought to put a tricolor led on the XK-1 too :)
-
- XCore Addict
- Posts: 207
- Joined: Thu Dec 10, 2009 11:00 pm
- Location: Mexico
RGB LED is a must! :)
-
- Active Member
- Posts: 50
- Joined: Wed Dec 16, 2009 6:04 pm
- Location: London
i think you could make a nice (compact) replacement for a volume level (VU) led-bar with one RGB LED :))otitov wrote:RGB LED is a must! :)
-
- XCore Addict
- Posts: 207
- Joined: Thu Dec 10, 2009 11:00 pm
- Location: Mexico
it would be nice, but how to implement peak indication?
-
- XCore Expert
- Posts: 546
- Joined: Thu Dec 10, 2009 10:41 pm
- Location: St. Leonards-on-Sea, E. Sussex, UK.
White? It could go through a range of colours indicating the level. One red LED could be used with the level indicated by flash rate.
-
- XCore Addict
- Posts: 207
- Joined: Thu Dec 10, 2009 11:00 pm
- Location: Mexico
point taken!
-
- XCore Addict
- Posts: 238
- Joined: Thu Dec 17, 2009 5:15 am
Have it speak Morse code, that is, short very short synonymic points.
Color would determine mode. then you could have it throb between
colors at differing rates all from one fine LED. ; )
Color would determine mode. then you could have it throb between
colors at differing rates all from one fine LED. ; )