The xconnect architecture document sure suggests so:
Par 1.2:
Channel-ends can be allocated and freed dynamically, and their destination can
be set dynamically. However, once a channel is in use as a stream, its destination
cannot be changed until the stream has finished. Services can be implemented
using many-to-one channels, where multiple channel-ends all point to a single one.
Each of the channel-ends can transmit tokens to the shared channel-end, but if
two circuits are created simultaneously to a single channel-end, then one circuit
will take precedence and be connected, and the other one is blocked until the first
circuit is terminated by an END.
Can links be setup dynamically using XC or assembly? Topic is solved
-
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
-
- XCore Addict
- Posts: 161
- Joined: Sun Jun 12, 2011 11:47 am
By chance I stumbled across this wiki entry:
https://www.xcore.com/wiki/index.php?ti ... y_Paolomio
It is for L architecture so it should work on multiple startkits.
https://www.xcore.com/wiki/index.php?ti ... y_Paolomio
It is for L architecture so it should work on multiple startkits.