So it looks I lumped my XC-2 wall-wart together with all the others I dumped at GoodWill. Although I could drag my bench powersupply up and wire something up myself, it'd be nicer to have something I can just plug in. Anyone know where I can get one in the US, what the power requirements are (1A IIRC) and the size of the plug?
Cheers!
XC-2 Wall Wart?
-
- XCore Addict
- Posts: 133
- Joined: Tue Dec 15, 2009 10:23 pm
-
- XCore Expert
- Posts: 844
- Joined: Sun Jul 11, 2010 1:31 am
5V 1.2A. The board has a 1.1A fuse. The plug looks like a hollow
3.5mm barrel; center positive.
3.5mm barrel; center positive.
-
- XCore Addict
- Posts: 133
- Joined: Tue Dec 15, 2009 10:23 pm
Looks like it's smaller than 3.5mm to me though... Hmm... Anyone else? :-)
-
- Respected Member
- Posts: 279
- Joined: Fri Dec 11, 2009 1:34 pm
-
- XCore Addict
- Posts: 133
- Joined: Tue Dec 15, 2009 10:23 pm
The output jack in the catalog looks like it's too big ( 5.5mm ) so I'm leaning towards 1.35mm x 3.5mm jack, which seems to be the right size...
$3.79 on eBay, free shipping :-)
$3.79 on eBay, free shipping :-)
-
- XCore Addict
- Posts: 146
- Joined: Thu Dec 10, 2009 10:17 pm
Yup. Outside of barrel according to digital calipers, 3.12mm.
-
- XCore Expert
- Posts: 546
- Joined: Thu Dec 10, 2009 10:41 pm
- Location: St. Leonards-on-Sea, E. Sussex, UK.
Probably a 1.3 mm connector:
http://www.rapidonline.com/netalogue/specs/20-0900.pdf
The OD is 3.5 mm, though.
http://www.rapidonline.com/netalogue/specs/20-0900.pdf
The OD is 3.5 mm, though.
-
- XCore Addict
- Posts: 146
- Joined: Thu Dec 10, 2009 10:17 pm
I think there is a lot of clearance on the outside of the barrel. The main fit is on the pin.