Upon upgrading to the latest version of xTIMEcomposer (13.1.0), a re-install of the drivers for the StartKIT was required. However, the driver installation failed (Windows driver installation failure message and xTIMEcomposer could not find the startKIT.) Does anybody have a link to the drivers for it? I'm running Windows 7 64 bit.
EDIT:I had to install version 13.0.2 and everything is working again so it looks like as long as I keep the older version 13.0.2 installed everything works fine including version 13.1.0.
XMOS StartKIT driver installation failure
-
- Junior Member
- Posts: 6
- Joined: Sun May 11, 2014 1:54 am
XMOS StartKIT driver installation failure
Last edited by nickn on Mon May 26, 2014 2:40 pm, edited 5 times in total.
-
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
what error are you getting? Which version of xTIMEcomposer are you running?
Sethu.
Sethu.
-
- Junior Member
- Posts: 6
- Joined: Sun May 11, 2014 1:54 am
Just updated OP.
-
- Junior Member
- Posts: 6
- Joined: Sun May 11, 2014 1:54 am
It appears that I spoke too soon. Upon disconnecting and reconnecting the startKIT after I installed the older version and then trying to run a program it prompts a driver installation which fails.
The message I get upon trying to run the program:
"xrun: No available devices"
EDIT: Going back to 13.0.2 I was getting the same message but after a disconnect/reconnect of the device it's working again. Strange.
So to sum it all up:
I install version 13.1.0 with the startKIT connected.
I use the startKIT just fine.
I reconnect the startKIT.
A driver installation starts and fails and I get the message "xrun: No available devices"
I close 13.1.0 and go to 13.0.2.
I still the the message "xrun: No available devices"
I reconnect the startKIT
It's working fine again under 13.0.2.
The message I get upon trying to run the program:
"xrun: No available devices"
EDIT: Going back to 13.0.2 I was getting the same message but after a disconnect/reconnect of the device it's working again. Strange.
So to sum it all up:
I install version 13.1.0 with the startKIT connected.
I use the startKIT just fine.
I reconnect the startKIT.
A driver installation starts and fails and I get the message "xrun: No available devices"
I close 13.1.0 and go to 13.0.2.
I still the the message "xrun: No available devices"
I reconnect the startKIT
It's working fine again under 13.0.2.