Licence / Open Source / GPL

Non-technical related questions should go here.
Active Member
Posts: 33
Joined: Tue Feb 16, 2016 12:51 pm

Licence / Open Source / GPL

Postby nico » Sat May 26, 2018 11:31 am

Hi everyone,

I am not sure to post in the right section ...

I would like to design a fully open source / libre usb audio board.
I will base my design on the reference design XK-AUDIO-216-MC-AB and I may use the USB audio stack 6.15.2rc1 as a starting base for the final firmware.

From what I understand, I cannot use part of this code in my final code and release my final code under GPL (or similar licence), is that right ?

Best regards,
User avatar
XCore Addict
Posts: 241
Joined: Wed May 31, 2017 6:55 pm

Postby CousinItt » Sat Jun 02, 2018 7:00 pm

It looks like you can't do that.

See 5.2 in the licence agreement (
User avatar
XCore Expert
Posts: 522
Joined: Thu Nov 26, 2015 11:47 pm

Postby akp » Tue Jun 12, 2018 2:13 pm

Looks like you will have to build your own code based on the publicly available USB documents and XMOS datasheets. Good luck!

Who is online

Users browsing this forum: No registered users and 1 guest