xCORE-200 Explorer kit Gigabit TCP ??
Posted: Sun Jul 17, 2016 7:57 am
I've gone through the Gigabit Ethernet example for Explorer kit, which was very nice, and it responds to pings. However, how do I go the next step to do something useful other than answer pings, i.e. send data?
I found another older AppNote 121 that is a UDP demo, and tried to figure out how to cut and paste the xtcp functionality onto the Explorer kit gigabit ethernet, but couldn't get it working. There must be some sample code somewhere out there that uses the Explorer kit's gigabit ethernet to do something practical using TCP/IP or UDP? I have never dove deeper than just sending UDP messages, so the lower-layer distinctions between MII's and MAC's are lost on me. Anything that shows how to successfully wire the xtcp functionality onto the explorer kit and use it would be so nice.
Many thanks in advance.
I found another older AppNote 121 that is a UDP demo, and tried to figure out how to cut and paste the xtcp functionality onto the Explorer kit gigabit ethernet, but couldn't get it working. There must be some sample code somewhere out there that uses the Explorer kit's gigabit ethernet to do something practical using TCP/IP or UDP? I have never dove deeper than just sending UDP messages, so the lower-layer distinctions between MII's and MAC's are lost on me. Anything that shows how to successfully wire the xtcp functionality onto the explorer kit and use it would be so nice.
Many thanks in advance.