I work for a company which creates test hardware for Factories.
I have been assigned to create a test Jig for a product containing a D-XVF3000-1.
I am required program the D-XVF3000-1 also.
I have had a look at your website and datasheet, and while there is lots of fantastic information about developing for this device,
I havn't found any information about production programming.
Things to note about production programming:
1 - I need to know which hardware, and which software I need to program this device in production
2 - there is very little human interaction.
The human will insert the PCB into the test jig and press "go".
The computer is required to run the programming software
3 - I opened up a support ticket, and was told the following:
Off Topic
Hello Andrew,
Thank you very much for your enquiry.
We do not have one of these generally available but it is possible our Engineers do.
I would suggest that you ask on our support site http://www.xcore.com, which is monitored by our engineers.
Thank you very much for your enquiry.
We do not have one of these generally available but it is possible our Engineers do.
I would suggest that you ask on our support site http://www.xcore.com, which is monitored by our engineers.
any advice would be greatfully received.
Best regards
Andrew