fabrication in UK

Non-technical related questions should go here.
ast8346
Active Member
Posts: 39
Joined: Mon Jan 05, 2015 12:58 am

Post by ast8346 »

Ok
sounds good
Thanks


User avatar
Folknology
XCore Legend
Posts: 1274
Joined: Thu Dec 10, 2009 10:20 pm
Contact:

Post by Folknology »

From memory I think I use a 0.2mm track width to go in between the balls on the Xmos BGA chips, I tend to use a metric setting on those designs. I generally do not have to go underneath to route the signals out (other than for via spacing/density reasons). This works fine for me with the higher spec DRU from PCB-pool for example.

regards
Al
Post Reply