Oh, OK. Thanks. Then I'm doing something wrong with the wake up timer since it's waking faster/sooner than it should.
I'll continue to play around.
Cheer,
Red
XS1-U12: DCDC2 (analogue supply) & Power when Asleep
Have a look whether the bit is set or not, and how much too fast it wakes up.
The power consumption should also tell you - it shouldn't take a lot on 32 kHz, but more on 20 MHz.
The power consumption should also tell you - it shouldn't take a lot on 32 kHz, but more on 20 MHz.
OK it was my mistake, I wasn't using the full 64 bit and missing a 0 when working out the timer value, so it was waking after 6 seconds when I was expecting it to wake after a minute.
Will hand back to our hardware guy to go over and check power again.
Thanks for all the help,
Red
Will hand back to our hardware guy to go over and check power again.
Thanks for all the help,
Red