How to erase/reset xCORE-200 (XE216-512-TQ128)
Posted: Wed Jun 30, 2021 4:43 am
Hi everyone,
I have a board with XE216-512-TQ128 on it. This board is essentially a copy-paste design of a xCORE-200 eXplorerKIT wit few additional components.
I used the board for a couple of day and it was working fine, I'm able to xrun and xflash the new firmware.
However today I noticed that no matter what, board seems to be running an older version of FW that I can not overwrite.
First I tried running `xrun binary-file` then I tried `xflash binary-file` and both of them pass. However after reset board continues to run old firmware.
I also tried running `xflash --erase-all --target-file xk-audio-216-mc.xn` and it passes, however it still runs old firmware.
I'm a total newbie so I would appreciate any help on how to "reset" or "restore" XE216 so I can run firmware with `xrun`.
Thank you in advance!
I have a board with XE216-512-TQ128 on it. This board is essentially a copy-paste design of a xCORE-200 eXplorerKIT wit few additional components.
I used the board for a couple of day and it was working fine, I'm able to xrun and xflash the new firmware.
However today I noticed that no matter what, board seems to be running an older version of FW that I can not overwrite.
First I tried running `xrun binary-file` then I tried `xflash binary-file` and both of them pass. However after reset board continues to run old firmware.
I also tried running `xflash --erase-all --target-file xk-audio-216-mc.xn` and it passes, however it still runs old firmware.
I'm a total newbie so I would appreciate any help on how to "reset" or "restore" XE216 so I can run firmware with `xrun`.
Thank you in advance!