Remove LED program in starKIT.
Posted: Mon Jul 08, 2019 1:31 pm
Hello guys!!!
Actually yesterday I was working one project and somehow I wanted to check it works fine or not I tried to write down program basically LED glowing example.
When it worked perfectly so I started one another project and over time build and test it worked perfectly.
When I did write down another example into startKIT it perfectly flash it.
But the problem occurs when hardware working previously flashed program(glowing led example).
I tried so many time but still, it shows the same result.
Even I did read artical related for this problem and short the spi cs pin 1 and 3.3v pin on power off mode.
When I power up still glow the 5 leads in an x pattern.
I hope you will help with this problem.
Thanks in advance.
Actually yesterday I was working one project and somehow I wanted to check it works fine or not I tried to write down program basically LED glowing example.
When it worked perfectly so I started one another project and over time build and test it worked perfectly.
When I did write down another example into startKIT it perfectly flash it.
But the problem occurs when hardware working previously flashed program(glowing led example).
I tried so many time but still, it shows the same result.
Even I did read artical related for this problem and short the spi cs pin 1 and 3.3v pin on power off mode.
When I power up still glow the 5 leads in an x pattern.
I hope you will help with this problem.
Thanks in advance.