Flash Programming on eXplorer Kit
Posted: Wed Jul 03, 2019 11:48 am
I’m having problems programming the flash memory in the XC-200 eXplorer Kit development board using an executable file that I can run successfully on it via the Run Configurations. This is the first time that I’ve used the command line environment or tried to program the flash memory.
If I double-click on the SetEnv.command icon in MacOS Finder to launch a Terminal session, typing the xflash -l option to identify the connected JTAG adapter, then that works ok, but then attempting to flash the XC-200 eXplorer Kit from the command line results in a file not found, even though the .xe file exists in the Workspace.
xflash —id ID program.xe as described in Section 26.1 of the xTIMEcomposer User Guide results in the below error.
If I attempt to flash the eXplorer Board via the development environment, I get an internal error.
What am I missing please?
If I double-click on the SetEnv.command icon in MacOS Finder to launch a Terminal session, typing the xflash -l option to identify the connected JTAG adapter, then that works ok, but then attempting to flash the XC-200 eXplorer Kit from the command line results in a file not found, even though the .xe file exists in the Workspace.
xflash —id ID program.xe as described in Section 26.1 of the xTIMEcomposer User Guide results in the below error.
If I attempt to flash the eXplorer Board via the development environment, I get an internal error.
What am I missing please?