Progress has been slow due to the missing capacitors. I got some so I resumed building the board. This weekend it should be finished, wish me luck !
Ale
Are there any boards with external SRAM/SDRAM available ?
-
- Respected Member
- Posts: 259
- Joined: Thu Sep 16, 2010 9:15 am
-
- XCore Expert
- Posts: 956
- Joined: Fri Dec 11, 2009 3:53 am
- Location: Sweden, Eskilstuna
Is the board working now?
(I tried dragsoldering with a dragsolder tip + alot of flux/no flux white paste. (I do not remeber the mix in the paste, it was very easy and fast to solder with it ! )
(I tried dragsoldering with a dragsolder tip + alot of flux/no flux white paste. (I do not remeber the mix in the paste, it was very easy and fast to solder with it ! )
Probably not the most confused programmer anymore on the XCORE forum.
-
- Respected Member
- Posts: 259
- Joined: Thu Sep 16, 2010 9:15 am
Hei,
I did solder over the weekend the L1... boy that was no Ponyhof :(. I did not test it yet but at least there are no short-circuits. I have to test the 1V & 3v3 rails (GND looks ok) and then I'll power it up. Wish me luck.
I did solder over the weekend the L1... boy that was no Ponyhof :(. I did not test it yet but at least there are no short-circuits. I have to test the 1V & 3v3 rails (GND looks ok) and then I'll power it up. Wish me luck.
-
- Member
- Posts: 13
- Joined: Fri Dec 11, 2009 10:51 am
http://www.dsp4you.com/onlineshop?page= ... egory_id=6
G4 + SRAM
Too bad they don't sell individual units.
G4 + SRAM
Too bad they don't sell individual units.