Page 2 of 2
Re: xrun: Cannot load image, XCore 0 is not enabled
Posted: Thu Aug 30, 2018 9:02 am
by xlordofpainx
I am using usb in and 2 spdif ins. And while i can power it with USB i am using just 2 poles and an external power supply for the 5V
Re: xrun: Cannot load image, XCore 0 is not enabled
Posted: Thu Aug 30, 2018 9:05 am
by xlordofpainx
New fresh error - Error on tile[0]: failed to connect to flash device. Please verify that SQI type is supported and that the correct SQI ports are defined within your xn file. Looking into it i did find similar posts and I am using the default codes, but I don't know how to proceed with adapting to my situation.
xflash: Error: F03096 Node "0" is configured to boot from a device but no suitable device was found.
This posts when i try flashing a new Hello world onto it
Re: xrun: Cannot load image, XCore 0 is not enabled
Posted: Thu Aug 30, 2018 9:54 am
by mon2
Post full part number and vendor of the flash being used.
Re: xrun: Cannot load image, XCore 0 is not enabled
Posted: Thu Aug 30, 2018 9:59 am
by xlordofpainx
SST26VF016-80-5I-S2AE FLASH MEMORY, 16MBIT, 80MHZ, SOIC-8 85423275 Manufacturer code - SST26VF016-80-5I-S2AE -- -Bought from Farnell
Re: xrun: Cannot load image, XCore 0 is not enabled
Posted: Thu Aug 30, 2018 12:52 pm
by xlordofpainx
I used an osciloscope to monitor what happens to the pins during flash and a spike is always present when it tries to flash so connection is out of the way i guesss