Does Slicekit x200 have xConnect?
Posted: Mon Aug 13, 2018 8:34 pm
Using slice kit XM-SCK-X200 1V0 main board, I get no console printf, printstr, or debug_printf() when Im running anything more complicated than uart software. When I run the same code on the xCORE-200 MC AUDIO board, the prints work. Any code that tries to print seems to lock up the software even stopping enumeration. Does this board have the xConnect? The documentation and schematics in xCORE-200-sliceKIT-Hardware-Manual_1.0.pdf dont show the specific connect pins, though they do show connections to tile[0].
Am I supposed to configure something in the software to enable connection through these pins?
Any suggestions on how to get meaningful real time data (such as "Where is my audio for DAC0") off this board while running reference code?
I saw post: http://www.xcore.com/viewtopic.php?t=2801, and looked for a switch to enable xCONNECT - didn't see one.
Any help will be much appreciated.
Am I supposed to configure something in the software to enable connection through these pins?
Any suggestions on how to get meaningful real time data (such as "Where is my audio for DAC0") off this board while running reference code?
I saw post: http://www.xcore.com/viewtopic.php?t=2801, and looked for a switch to enable xCONNECT - didn't see one.
Any help will be much appreciated.