Programming interface
Posted: Sun Jun 11, 2017 3:39 pm
Hello all,
I have been looking at the xcore MCUs as a possible dsp/motor controller. I can see that loading programs to the startKIT dev board is just directly via USB and xTime, but (at the risk of sounding pants on head stupid) what about standalone chips? I have no experience in this area other than programming AVR via usbasp, but as far as I can see it would be done via the JTAG pins, and that would interfaced to xTime via an XA-XTAG adapter. Is this correct?
I haven't been able to find any guide on programming stand-alone chips, annoyingly, so I'd appreciate any pointers in the right direction.
Thanks.
I have been looking at the xcore MCUs as a possible dsp/motor controller. I can see that loading programs to the startKIT dev board is just directly via USB and xTime, but (at the risk of sounding pants on head stupid) what about standalone chips? I have no experience in this area other than programming AVR via usbasp, but as far as I can see it would be done via the JTAG pins, and that would interfaced to xTime via an XA-XTAG adapter. Is this correct?
I haven't been able to find any guide on programming stand-alone chips, annoyingly, so I'd appreciate any pointers in the right direction.
Thanks.