Page 1 of 1
xConfigurator - how is launched?
Posted: Sat Aug 27, 2016 6:26 pm
by fotis
Hi
I try to launch the xConfigurator utility just for testing. My PC OS is Windows 7 pro 64 bit. When the xConfigurator is launched, it instantly opens and close a MSDOS window. I can't see anything else.
Is that normal? How does xConfigurator produces the binary file for the flash memory?
Attached is a picture of the "default.cfg" file opened from my programming device. Is this hex file ready to flash the QSPI memory?
Thanks
Fotis
Re: xConfigurator - how is launched?
Posted: Tue Aug 30, 2016 9:30 am
by henk
Hi Fotis,
You probably have to run xconfigurator from the command line.
Cheers,
Henk
Re: xConfigurator - how is launched?
Posted: Tue Aug 30, 2016 9:30 am
by fotis
henk wrote:Hi Fotis,
You probably have to run xconfigurator from the command line.
Cheers,
Henk
Hi Henk
Thank you so much for the reply.
I tried it but... see in the attached picture what shows the msdos command line.
What is going wrong?
Re: xConfigurator - how is launched?
Posted: Tue Aug 30, 2016 11:58 am
by henk
Hi,
Yes, you need to create a configuration file, for example the one that came in the ZIP file (default.cfg for example). In the ZIP file you will also find a PDF directory with an "xCORE-AUDIO configuration guide" that will be helpful; it explains the syntax of the configuration file.
Note that this will help you to build a flash image that will make the device configure itself on boot-up. If you want to configure the device whilst it is running (for example, you want to set the volume, sample rate, etc) you will have to use the tools that your O/S offers.
Cheers,
Henk
Re: xConfigurator - how is launched?
Posted: Wed Aug 31, 2016 8:00 am
by fotis
Thanks Henk for the advice
Job done!
However a more precise guidance is as follows:
1) After unpacking the downloaded ZIP file a new directory xCORE-AUDIO-configuration-utility_1.0.0 is created in Downloads
2) Locate the xConfigurator.exe file found in subfolder. Cut and paste the file in Downloads.
3) The two configuration files hi_res_2_dac__hpa.cfg and default.cfg also are into xCORE-AUDIO-configuration-utility_1.0.0 directory. Cut and paste both files in Downloads
4) From the Windows start menu select Accessories and then click on Command Prompt C:\ . A MSDOS window opens and the command line usualy is C:\users\your pc name\Downloads>.
5) To open the hi_res_2_dac__hpa.cfg type exactly the following in the command line:
xConfigurator -c hi_res_2_dac_hpa.cfg -o custom_xhra_firmware.bin
Press ENTER and the binary file will be created again under the Downloads directory.
You can locate the binary file under the group file BIN
Thank you
Fotis
Re: xConfigurator - how is launched?
Posted: Fri Oct 27, 2017 11:27 am
by dutcher
I don't understand the last part
Re: xConfigurator - how is launched?
Posted: Fri Oct 27, 2017 11:27 am
by dutcher
I have the same problem but don't know how to fix it