Initial pin/port configuration/status for L series silicon
Posted: Mon Apr 26, 2010 5:30 pm
What is the default configuration and state of a 1 bit port/pin (or others for that matter) after reset.
i.e. what would be the state (and config) of any of the unused 1 bit ports (excluding SPI pins) on the L1-64 when it access the flash. Obviously I am assuming a default SPI boot process in this example.
I couldn't find this in the docs, I assume it is consistent.
i.e. what would be the state (and config) of any of the unused 1 bit ports (excluding SPI pins) on the L1-64 when it access the flash. Obviously I am assuming a default SPI boot process in this example.
I couldn't find this in the docs, I assume it is consistent.