Hi,
I am working with the AVS dev-board mentioned above. I would like to configure the signal processing blocks used, such as change AEC parameters, switch off noise reduction, etc.
Is there any way to do that?
Thank you for any help
Configuring audio processing blocks on VocalFusion 4-Mic Kit for Amazon AVS
-
adrian
- Newbie
- Posts: 1
- Joined: Wed May 30, 2018 5:58 pm
-
infiniteimprobability
- XCore Legend
- Posts: 1124
- Joined: Thu May 27, 2010 10:08 am
See the control guide (sw_vocalfusion_control_guide.pdf) in the published software..