XC-1 Dimensions

Technical discussions related to any XMOS development kit or reference design. Eg XK-1A, sliceKIT, etc.
Post Reply
User avatar
Andy
Respected Member
Posts: 279
Joined: Fri Dec 11, 2009 1:34 pm

XC-1 Dimensions

Post by Andy »

Has anyone got dimensions of the XC-1 with the locations and size of the headers labelled? I'm designing a board to slot on top and was hoping for something a little more accurate than using a ruler.


User avatar
Berni
Respected Member
Posts: 363
Joined: Thu Dec 10, 2009 10:17 pm
Contact:

Post by Berni »

Download the gerbers off the xmos website and measure those. On the XC-2 i found that all the pins fit a 2,54mm grid so you can use a prefboard.
User avatar
Andy
Respected Member
Posts: 279
Joined: Fri Dec 11, 2009 1:34 pm

Post by Andy »

Do have any recommendations for software to view and measure the gerbers?
User avatar
leon_heller
XCore Expert
Posts: 546
Joined: Thu Dec 10, 2009 10:41 pm
Location: St. Leonards-on-Sea, E. Sussex, UK.
Contact:

Post by leon_heller »

I imported the top layer into the Pulsonix PCB software I used and added the most important dimensions. A GIF of a screen-dump with the dimensions is here:

http://www.leonheller.com/images/XC-1.gif

I can add any more dimensions you need. You could download the Pulsonix demo and import my PCB file into it, and add your own dimensions. You could import the Gerber yourself, but you wouldn't be able to save the PCB.

I've added a PDF:

http://www.leonheller.com/images/XC-1.pdf
User avatar
Andy
Respected Member
Posts: 279
Joined: Fri Dec 11, 2009 1:34 pm

Post by Andy »

Thanks, Leon.
Post Reply