SP'I boot question, HW related

Technical discussions around xCORE processors (e.g. General Purpose (L/G), xCORE-USB, xCORE-Analog, xCORE-XA).
User avatar
DrFingersSchaefer
Experienced Member
Posts: 65
Joined: Fri Dec 18, 2009 1:27 pm
Location: The Interzone

Re: SP'I boot question, HW related

Postby DrFingersSchaefer » Sat Jan 30, 2010 12:55 pm

Yup, already got all that.

The XC-1 comes without external SPI to boot from and the demos are buned into the OTP. It is configured to boot from this code in OTP. I read in the forums that there is a hack to stop it doing this and enable it to boot from external SPI. The fourm unfortunately failed to say what the hack was.....
"Dr Fingers Schaefer, The Lobotomy Kid"
Caesar ad sum iam forti
Brutus ad erat
Caesar sic in omnibus
Brutus sic in at
:ugeek:
User avatar
paul
XCore Addict
Posts: 169
Joined: Fri Jan 08, 2010 12:13 am

Postby paul » Sun Jan 31, 2010 12:34 am

A combination of this and this should get you where you need to go for the XC-1 SPI boot conversion (note: not needed for XC-1A)

Good luck!
Paul

On two occasions I have been asked, 'Pray, Mr. Babbage, if you put into the machine wrong figures, will the right answers come out?' I am not able rightly to apprehend the kind of confusion of ideas that could provoke such a question.

Who is online

Users browsing this forum: No registered users and 3 guests