Technical discussions around xCORE processors (e.g. General Purpose (L/G), xCORE-USB, xCORE-Analog, xCORE-XA).
2 posts • Page 1 of 1
- Active Member
- Posts: 46
- Joined: Tue Nov 02, 2010 4:53 pm
XC-2 Ethernet Kit comes with design files. But what software can you use to with them?
- XCore Expert
- Posts: 546
- Joined: Thu Dec 10, 2009 10:41 pm
- Location: St. Leonards-on-Sea, E. Sussex, UK.
They are Gerber and drill files that can be used to get your own XC-2 PCBs manufactured. They can be viewed in a Gerber viewer such as GC-Prevue.
Who is online
Users browsing this forum: No registered users and 1 guest