Upon upgrading to the latest version of xTIMEcomposer (13.1.0), a re-install of the drivers for the StartKIT was required. However, the driver installation failed (Windows driver installation failure message and xTIMEcomposer could not find the startKIT.) Does anybody have a link to the drivers for it? I'm running Windows 7 64 bit.
EDIT:I had to install version 13.0.2 and everything is working again so it looks like as long as I keep the older version 13.0.2 installed everything works fine including version 13.1.0.
XMOS StartKIT driver installation failure
XMOS StartKIT driver installation failure
Last edited by nickn on Mon May 26, 2014 2:40 pm, edited 5 times in total.
- sethu_jangala
- XCore Expert
- Posts: 589
- Joined: Wed Feb 29, 2012 10:03 am
what error are you getting? Which version of xTIMEcomposer are you running?
Sethu.
Sethu.
Just updated OP.
It appears that I spoke too soon. Upon disconnecting and reconnecting the startKIT after I installed the older version and then trying to run a program it prompts a driver installation which fails.
The message I get upon trying to run the program:
"xrun: No available devices"
EDIT: Going back to 13.0.2 I was getting the same message but after a disconnect/reconnect of the device it's working again. Strange.
So to sum it all up:
I install version 13.1.0 with the startKIT connected.
I use the startKIT just fine.
I reconnect the startKIT.
A driver installation starts and fails and I get the message "xrun: No available devices"
I close 13.1.0 and go to 13.0.2.
I still the the message "xrun: No available devices"
I reconnect the startKIT
It's working fine again under 13.0.2.
The message I get upon trying to run the program:
"xrun: No available devices"
EDIT: Going back to 13.0.2 I was getting the same message but after a disconnect/reconnect of the device it's working again. Strange.
So to sum it all up:
I install version 13.1.0 with the startKIT connected.
I use the startKIT just fine.
I reconnect the startKIT.
A driver installation starts and fails and I get the message "xrun: No available devices"
I close 13.1.0 and go to 13.0.2.
I still the the message "xrun: No available devices"
I reconnect the startKIT
It's working fine again under 13.0.2.